Siemens SIMATIC ET 200SP CM 1xDALI, Manual, Page: 81 / 126

Programming
5.7 Configuration function blocks
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
80
Manual, 06/2019, A5E46959434-AA
Parameter
The following table shows the parameters of the function block:
Parameter Declaration Data type Memory
area
Description
SET Input
BOOL I, Q, M, D,
L or Con-
stant
Set extended parameters of the control gear upon a rising edge.
ADDRES
S
USInt I, Q, M, D,
L or Con-
stant
Specify the short address of the device.
Range: 0 to 63
ECG_TYP
E
USInt I, Q, M, D,
L or Con-
stant
Device type of the control gears. Refer to Electric control gear (ECG)
type (Page 107).
Range:1, 4 to 8
EXT_PRM
_SET
1
Ar-
ray[0..17]
of BYTE
I, Q, M, D,
L or Con-
stant
The parameters are set to the control gear.
CM_DALI InOut "DALI_CT
RL"
The data block of DALI_CTRL specifies the CM 1xDALI which com-
municates with the current function block.
BUSY Output BOOL I, Q, M, D,
L
Status parameter:
•
BUSY = 0: Processing of job is terminated.
•
BUSY = 1: Job is still being committed.
ACTIVE BOOL I, Q, M, D,
L
Status parameter:
•
ACTIVE = 0: Job is not yet started.
• ACTIVE = 1: Job is being executed.
DONE BOOL I, Q, M, D,
L
Status parameter:
•
DONE = 0: Job is not yet started or still executing.
• DONE = 1: Job is executed without errors.
ERROR BOOL I, Q, M, D,
L
Status parameter:
• ERROR = 0: No error occurs.
•
ERROR = 1: Error occurs during processing.
STATUS BYTE I, Q, M, D,
L
When ERROR = 0, STATUS has
following three values:
•
16#00: Idle
• 16#01: Executing
•
16#7F: Completed
When ERROR = 1, STATUS
shows the detailed error code. For
the detailed meaning of each
error code, refer to Parameter
STATUS (Page 106).
1
For the detailed description of the extended parameters for DALI control gears, refer to the following table.