Siemens SIMATIC ET 200SP CM 1xDALI, Manual, Page: 100 / 126

Programming
5.7 Configuration function blocks
ET 200SP Communication module CM 1xDALI (6ES7137-6CA00-0BU0)
Manual, 06/2019, A5E46959434-AA
99
Parameter Declaration Data type Memory
area
Description
CM_DALI InOut "DALI_CT
RL"
The data block of DALI_CTRL specifies the CM 1xDALI which
communicates with the current function block.
BUSY
Output BOOL I, Q, M, D,
L
Status parameter:
• BUSY = 0: Processing of job is terminated.
•
BUSY = 1: Job is still being committed.
ACTIVE BOOL I, Q, M, D,
L
Status parameter:
•
ACTIVE = 0: Job is not yet started.
• ACTIVE = 1: Job is being executed.
DONE BOOL I, Q, M, D,
L
Status parameter:
•
DONE = 0: Job is not yet started or still executing.
• DONE = 1: Job is executed without errors.
ERROR BOOL I, Q, M, D,
L
Status parameter:
•
ERROR = 0: No error occurs.
•
ERROR = 1: Error occurs during processing.
STATUS BYTE I, Q, M, D,
L
When ERROR = 0, STATUS has
following three values:
•
16#00: Idle
• 16#01: Executing
•
16#7F: Completed
When ERROR = 1, STATUS
shows the detailed error code.
For the detailed meaning of each
error code, refer to Parameter
STATUS (Page 106).
1
For the detailed description of sensor instance type-related parameters for configuring DALI_SENSOR_INST_PARAM,
refer to the following table.
Table 5- 5 Sensor instance type-related parameters for configuring DALI_SENSOR_INST_PARAM
Attributes BYTE Type 1 (push button) Type 2 (absolute input) Type 3 (occupancy) Type 4 (light sensor)
Read/Write 0 tShort Deadtime Hold time Hysteresis
1
tDouble
Report time Report time Hysteresis min
2
tRepeat
Not used Deadtime Report time
3
tStuck
Not used Deadtime