Before using for the first time
en
13
Cooking sensor function (optional)
Depending on the appliance version, the temperature
sensor will either be supplied with the appliance as a
standard accessory or will be available to order as an
optional accessory using the article no. below.
Operating modes
This appliance can be used in exhaust-air mode or
circulating-air mode.
Exhaust air mode
Note:
The exhaust air must not be conveyed into a
functioning smoke or exhaust gas flue or into a shaft
which is used to ventilate installation rooms which
contain heat-producing appliances.
■
Before conveying the exhaust air into a non-
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
■
If the exhaust air is conveyed through the outer wall,
a telescopic wall box should be used.
Circulating-air mode
Note:
To bind odours in circulating-air mode, you must
install an activated carbon filter. The different options for
operating the appliance in circulating-air mode can be
found in the brochure. Alternatively, ask your dealer.
The required accessories are available from specialist
outlets, from customer service or from the Online Shop.
K
Before using for the first
time
Before using for the first time
Please read the following information before using the
appliance for the first time:
Clean the appliance and all accessory parts thoroughly.
Before you can use your new appliance, you must apply
certain settings.
Initial use
Note:
When it is delivered, the appliance is preset to air
recirculation mode.
Possible settings:
■
In air recirculation mode, if
’‚ˆ
is displayed, the
value
‹
(factory setting) is set.
■
In air extraction mode, if
’‚ˆ
is displayed, the value
‚
is set.
To switch the appliance to air extraction mode, see
Temperature sensor
HZ39050
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The air which is drawn in is cleaned by the
grease filters and an activated carbon filter
and conveyed back into the kitchen.
