en
Cooking assist functions
28
Note:
Temperature setting 3/100
ºC is sufficient for
efficient boiling, even if the water does not boil very
strongly. However, the boiling point can be changed.
For example, you can set a lower altitude if you want the
water to boil more strongly.
Connecting the wireless temperature sensor to the
control panel
To connect the wireless temperature sensor to the
control panel, follow the instructions below:
1.
Select the basic setting
™‚…
; see the section on
The indicator for one of the hotplates and the
b
indicator will light up. The control panels switch off.
2.
Select the hotplate and its indicator will light up. A
signal will sound. The
õ
indicator will flash.
3.
Press the
»
symbol on the wireless temperature
sensor within 30 seconds.
After a few seconds, the status of the connection
between the temperature sensor and the control
panel will appear on the hotplate's display.
4.
Turn off the hob with the main switch to save the
settings.
■
The cooking functions are made available once the
temperature sensor has been connected to the
control panel correctly.
■
If there is a fault with the temperature sensor, the
connection may not be established correctly for the
following reasons:
– Bluetooth communication error.
– You did not press the symbol on the temperature
sensor within 30 seconds of selecting a hotplate.
– The battery in the temperature sensor has run
out.
Reset the wireless temperature sensor and follow
the connection procedure once again.
■
If the temperature sensor and the control panel are
not connected correctly due to a transmission error,
follow the connection procedure once again.
If the display continues to show incorrect connection
‚
, contact our technical after-sales service.
Resetting the wireless temperature sensor
1.
Touch and hold the
»
symbol for approximately
8-10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the LED
lights up for the third time, it will start to reset the
temperature sensor. At this point, you will need to lift
your finger off the symbol.
Once the LED goes out, this means that the wireless
temperature sensor has been reset.
2.
Repeat the connection procedure from point 2.
Setting procedure
1.
Attach the temperature sensor to the saucepan; see
the section on
"Preparing and maintaining the
2.
Place a saucepan filled with sufficient liquid on the
required hotplate and always put the lid on.
3.
Press the
»
symbol on the wireless temperature
sensor. The
õ
symbol for all hotplates will light up
on the control panel.
4.
Select the hotplate on which you have placed the
saucepan with the temperature sensor.
5.
Select the right temperature setting from the table.
The function has now been activated.
The temperature symbol
õ
will flash until the water
or oil has reached the right temperature for adding
the food. A signal will sound and the temperature
symbol will stop flashing.
6.
Once the signal has sounded, take the lid off and
add the food. Keep the lid on during cooking.
Note:
Do not cover the pan when using the "Frying
with a large amount of oil in the saucepan" function.
Switching off cooking functions
Select the hotplate and set it to
‹
in the control panel.
The hotplate will switch off and the residual heat
indicator will appear.
Note:
To re-activate the cooking functions, wait for
approximately 10
seconds.
600
- 800
m.
†
800
- 1000
m.
‡
1000
- 1200
m.
ˆ
1200
- 1400
m.
‰
Above 1400
m.
Š
Status
‹
Connected correctly
‚
Not connected correctly: Transmission error.
ƒ
Not connected correctly: Temperature sensor fault.
Height
Setting
™…
* Basic setting
R
R
