Siemens DCA Vantage, Operator'S Manual, Page: 109 / 214

DCA Vantage Operator’s Guide 109
Maint
e
na
nce
• Optical Tests
NOTE: If the system is set to restricted, to access System Tests you must
enter an authorized Operator ID and access code, refer to Operator IDs and
Access Codes ‚ page 42.
Performing User System Tests
The User System Tests screen enables you to test the DCA Vantage system.
1. At the System Menu screen, select
System Tests
.
2. From the System Test menu, select User System Tests .
3. Select the check box of the test you want to perform.
4. To initiate the test, select Start .
The tests that require no additional action automatically run.
NOTE: Some options may not be available because they were not configured
in your system.
The following table explains the different tests you can perform, if enabled,
and if they require additional action:
If you select . . . then. . .
Touchscreen Select each numbered key. The key changes from a
number to a check mark. If a section fails, the number
remains.
NOTE: The test times out if all the buttons are not
selected within 60 seconds.
Sound 1. Listen for an alert sound.
2. If you hear an alert sound, select
Yes
.
3. If you do not hear an alert sound, select No .
Door Open and close the door to verify that the screen
reflects the status of either the open or closed state.
Onboard Barcode
Reader Scan a DCA barcode with the onboard barcode
reader to verify that the onboard barcode reader
works properly.
External Barcode
Reader Scan a DCA barcode with the external barcode reader
to verify that the external barcode reader works
properly.
Onboard Printer Verify that the onboard printer prints a report.
External Printer Verify that the external printer prints a report.
Serial Port After connecting a loopback connector, the system
automatically runs the test.