Siemens Cerberus PYROTRONICS MXL, Operation, Installation, And Maintenance Manual

Page: 95 / 366

2 - 44
Installation
Switches S1, S2 and S4, Fuses F1 and F2, and Jumper J1
on the ZAC-30
OMM-1 Placement Requirements for the
ZAC-30
• Two primary ZAC-30s must be
diagonally placed in one OMM-1.
They cannot be mounted next to
each other.
Example: Primary ZAC-30s can be
placed at P7 and P6 OR P5 and P8.
• The horizontal OMM-1 slot next to a
primary ZAC-30 can be used for the
following:
1. ZC series cards placement
Example:
If P7 and P6 have primary
ZAC-30s, then P5 and P8 may have ZC
cards installed in them.
2. Dedicated one to one ZAC-30
backup for horizontally adjacent
primary ZAC-30.
Example: If P7 and P6 have primary
ZAC-30s, then P5 may have a ZAC-30
only if it is a one to one backup of P7.
P8 may have a ZAC-30 only if it is a
one to one backup of P6.
• When there is only one ZAC-30
primary amplifier on an OMM-1 at
location P7:
1. P5 may have a ZC card or a one
to one backup ZAC-30 for P7.
2. P8 and P6 have no restriction and
can have OCC-1s, ZCs, or one
backup for multiple ZAC-30s.
• The horizontal OMM-1 slot next to a
primary ZAC-30 may not be used as
a backup to multiple ZAC-30s.
Example: If P7 has a primary ZAC-30,
then P5 may not have a ZAC-30 that
backs up multiple ZAC-30s.
Setting the Address on the ZAC-30
Before installing the ZAC-30 in the
OMM, set the address on S1, DIP
switches SW1-SW4. Refer to the
CSG-M configuration printout for
the address of the module. Use the
ZAC-30 S1 Settings table to set the
address for this switch.
Configuring the ZAC-30
The switches for configuring the card
are located on the side of the card
opposite the heatsink assembly. The
fuses are located on the side of the
card with the heatsink assembly.
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com