Operating and parametrizing
8.1 Start up
Panel PC 670 V2/870 V2, Control unit
8-2
Operating Instructions, Edition 03/2004, CD Documentation and Drivers
Requirements
The following devices have been connected:
•
Computer unit
•
Control unit
•
PS/2 mouse
•
PS/2 keyboard
For additional information, refer to computer unit operating instructions.
Procedure
1. Turn on device
2. Install Microsoft Windows operating system.
3. Install applications and drivers.
8.1.2
Turn on device
Procedure
1. Decentralized design only: Plug the supplied power supply cable into the AC/DC power
supply connector of the decentralized control unit and lock it in place. Connect the power
supply cable to the supply network. The "POWER" LED will light up.
2. Plug the power plug of the supplied power supply cable in the AC/DC power supply
connector of the computer unit.
3. Lock the power plug in place. For Panel PC 670 only: clamp the supplied ferrite core onto
the power supply cable. This step can also be performed later. For additional information,
please refer to the chapter "Connecting" in the computer unit operating instructions.
4. Plug the power supply cable of the computer unit into a socket with a grounded protective
conductor.
5. If your computer has a power switch, turn on the computer unit at the power switch.
In the central design, not until now will the "POWER" LED illuminate. The device is now in
operation and booting.
Note
Applies to the decentralized design: If the picture signal is missing, e.g. when the
computer unit- control unit connecting cable is not plugged in, the control unit screen is
white.
Self test
After connection to the power supply, the device performs a self test. During the self test,
the message "Press <F2> to enter SETUP" appears briefly.
When the self test is finished, the operating system will be loaded.
