Operating Instructions
LMS1xx Laser Measurement Sensors
Transport and storage
8012471/ZN27/2017-06-09
© SICK AG · Germany · All rights reserved · Subject to change without notice
53
Chapter
4
4
Transport and storage
4.1
Transport
For your own safety, please read and observe the following notes:
Damage to the LMS1xx due to improper transport!
Package the device so that it is protected against collision and humidity.
Recommendation: use the original packaging for optimal protection.
Transport should be performed by trained specialist staff only.
The utmost care and attention is required at all times during unloading and
transportation on company premises.
Note the symbols on the packaging.
Do not remove packaging until immediately before you start mounting.
4.2
Transport inspection
Upon receipt, please check the delivery for completeness and for any damage that may
have occurred in transit. In the case of transit damage that is visible externally, proceed as
follows:
Do not accept the delivery or only do so conditionally.
Note the scope of damage on the transport documents or on the transport company's
delivery note.
File a complaint.
Important
Complaints regarding defects should be filed as soon as these are detected. Damage
claims are only valid before the applicable complaint deadlines.
4.3
Storage
Store the LMS1xx under the following conditions:
Recommendation: use the original packaging.
Do not store outdoors.
Store in a dry area that is protected from dust.
To ensure that any residual moisture present can escape, do not store the device in
airtight containers.
Do not expose to any aggressive substances.
Protect from sunlight.
Avoid mechanical shocks.
Storage ambient temperature range:
All variants except LMS14x: –30 °C to +70 °C (+70 °C maximum 24 h)
LMS14x: –40 °C to +70 °C (+70 °C maximum 24 h)
Relative humidity: max. 95%, non-condensing.
For storage periods of longer than 3 months, check the general condition of all
components and packaging on a regular basis.
