SICK LMC121, Operating Instructions Manual

Page: 13 / 110

Operating Instructions
LMS1xx Laser Measurement Sensors
For your safety
8012471/ZN27/2017-06-09 © SICK AG · Germany · All rights reserved · Subject to change without notice
13
Chapter 2
The following qualifications are necessary for the various tasks:
2.7 Hazard warnings and operational safety
Please observe the safety notes and the warnings listed here and in other chapters of these
operating instructions to reduce the possibility of risks to health and avoid dangerous
situations.
Safety notes
Please observe the following items in order to ensure the correct and safe use of the
LMS1xx.

The notices in these operating instructions (e.g. on use, mounting, installation or
integration into the existing machine controller) must be observed.

When operating the LMS1xx, the national, local and statutory rules and regulations
must be observed.

National/international rules and regulations apply to the installation, commissioning,
use and periodic technical inspections of the laser measurement sensor, in particular:
– the work safety regulations/safety rules
– other relevant health and safety regulations

Manufacturers and operators of the machine/system on which the LMS1xx is installed
are responsible for obtaining and observing all applicable safety regulations and rules.

The tests must be carried out by specialist personnel or specially qualified and author-
ized personnel and must be recorded and documented to ensure that the tests can be
reconstructed and retraced at any time.

The operating instructions must be made available to the operator of the system where
the LMS1xx is fitted. The operator of the system is to be instructed in the use of the
device by specialist personnel and must be instructed to read the operating
instructions.
Activities Qualification
Mounting and maintenance

Basic technical training

Knowledge of the current safety regulations in the
workplace
Electrical installation and
replacement

Practical electrical training

Knowledge of current electrical safety regulations
Commissioning, operation and
configuration

Basic knowledge of the Windows operating system

Basic knowledge of data transmission
Operation of devices in the related
application

Knowledge on the use and operation of devices in the
related application (e.g. crane, assembly system)

Knowledge on the software and hardware environment in
the related application (e.g. crane, assembly system)
Tab. 3: Authorized personnel