
In the
Visualization measurement value
area, the measured distance of the device is plotted
as a function of time. In addition, the switching points stored in the device for Q1
and Q2 are displayed graphically and their status is shown in the lower area (for
Di Q1 + Q2
process data selection). If
Di Signal quality
is selected as the
process data, the signal quality is visualized accordingly in the lower area.
7.3.3
Outputs Settings
This page is used to configure the safety-related functions (highlighted in yellow in the
graphs) and the non-safety-related functions. These can be assigned to the respective
outputs (digital output or analog current output). It is also possible in connection with
this for the device to perform several functions simultaneously.
In the following, the functions described in
"Safety-related functions", page 16
and the
associated parameters are explained in relation to a possible configuration.
Factory setting (for Q1 and Q2):
•
Switching function:
DtO mode
•
Digital output behavior:
Safety-related Zone near
7
COMMISSIONING AND CONFIGURATION
30
O P E R A T I N G I N S T R U C T I O N S | DT35S
8027663//2022-08-04 | SICK
Subject to change without notice