Sices HS 315, Technical Handbook

Page: 116 / 255

98 Technical Handbook
The engine related measurements are shown in this mode. The number of pages displayed
may depend on the type of engine (J1939, MTU or without communication interface). You can
scroll through the various pages using the LEFT and RIGHT buttons.
It contains the fundamental measurements for engine management:
•
Oil pressure
•
Coolant temperature
•
Speed
If any of these values is not available, it’ll be shown with dashes. If a CAN-BUS connection is
active, the type of engine selected is also displayed.
On the first row the name of the engine electronic control unit (ECU, if any) is displayed.
It contains other measurements for engine management:
•
Engine battery voltage.
•
Fuel level (%).
•
Fuel level (litres).
If any of these val
ues is not available, it’ll be shown with dashes.
This page contains various counters (managed by the controller board), which concern the
engine:
•
Cranks counter (resettable to zero).
•
Counter of operating hours (resettable to zero).
•
Counter of load operating hours with GCB closed (resettable to zero)
•
Counter of operating hours in OVERRIDE (resettable).
•
Counter of operating hours (total, not resettable to zero).
The first four counters are resettable (individually). To reset a counter, the operator must:
•
Press the ACK/ENTER button: one of the counters will be highlighted.
•
Use the vertical scrolling buttons UP and DOWN to select the counter you want to
reset to zero.
•
Press and hold the ACK/ENTER and ESC/SHIFT buttons for five seconds, until the
counter is cleared.
•
Press the ESC/SHIFT button.
From version 1.08, the counters are protected by the USER level. If a password has been
configured by means parameter P.0001, it is first required to type it (login) into parameter
P.0000, to be able to reset the counters.
This page is shown only if serial communication to the GERAFLEX engine is enabled.
Some engine measures acquired by serial port are shown in this page. Not available measures
are shown with dashes. This page shows the following measures
•
Signal of the correct oil pressure.
•
Battery Potential (Voltage), Switched (SAE J1939: SPN158).
•
Engine Intake Manifold #1 Temperature (SAE J1939: SPN105)
•
Engine Throttle Position (SAE J1939: SPN51).