SICE S 65 E, Instruction Manual

Page: 112 / 352

112 Operator's Manual
S 65 E - S 65 E C
displaying the following icon in the status bar.
The calculations performed by this programme are based on the unbalance values measured
during the last spin performed which must therefore refer to the wheel being serviced.
Proceed as follows to recall this programme:
- Select the OPT Flash icon
OPT STEP 1
1. take the valve to 12 o'clock;
2. press Enter to confirm the operation;
OPT STEP 2
3. turn the wheel until the valve gets to 6 o'clock position (the bottom arrow turns from
red to green);
4. make a chalk mark on the tyre external side at 12 o'clock;
5. confirm you marked the tyre by selecting Enter ;
6. remove the wheel from the wheel balancer.
7. Turn the tyre on the rim until the mark made matches the valve (180º rotation).
8. Refit the wheel on the wheel balancer and confirm the operation described in points
6 and 7 by selecting enter ;
Then, following the new indications on the monitor:
9.
Turn the wheel until the valve gets to 12 o'clock position:
10. press the Enter button to confirm the execution;
11. perform a spin.
Now, the real unbalance values of the wheel thus mounted on the wheel balancer are
displayed. Take the wheel to the position shown on the monitor. The foreseen unbalances
are displayed by performing the matching and the proportional improvement which can
be obtained if the user decides to continue the optimisation procedure.
In case optimising is insufficient, or significant improvements cannot be obtained, select
the Exit key twice (first to exit the procedure and restart the menu, and then to
exit the programme permanently); perform a spin to balance the wheel; otherwise, the