Showa DS-6200, Operating Manual

Page: 17 / 150

1 OUTLINE
16
OU
TLIN
E
Chapter
1
See the section on "Load cell connection" page 21 for connection.
See the section on "Voltage output connection" page 24 for connection.
See the section on "External I/O connection" page 22 for connection.
See the section on "External I/O connection" page 22 for connection.
See the section on "SI/F connection" page 21 for connection.
＋
EXC
－ EXC
＋ SIG
－ SIG
SHIELD
The terminal for connecting to a strain-gage sensor.
＋ MONITOR
－ MONITOR
The voltage output terminal for sensor input monitor.
→ page65 "Voltage Output Filter"
COM1 The terminal common to output signals.
OK
HI
LO
HH
LL
RUN Outputs the OK signal.
Outputs the HI signal.
Outputs the LO signal.
Outputs the HH signal.
Outputs the LL signal.
Outputs the RUN signal.
HOLD END
(H/E) Outputs the hold end signal.
→
page46 "Hold Functions"
EVENT Outputs the event signal when graph plotting ends.
COM2 The terminal common to input signals.
WORK0
WORK1
WORK2
WORK3(LOCK) Selects the work No. for the multi-hold function.
→
page57 "Multi-hold Function"
WORK3 is also usable as a LOCK terminal.
→
page65 "Screen Lock / Key Lock (B5 terminal function selection)"
T/H
SECTION
D/Z The input for digital zero (making the indicated value zero).
→ page38 "Digital Zero"
GRAPH
TRIG The input for controlling the drawing of graphic display.
→ page61 "Graph plotting"
CAL0
CAL1 Selects the CAL No. for calibration value selection function.
→ page30 "Calibration value selection by external signal input"
SI/F The 2-wire serial interface for coupling a printer, external display,
etc.
→ page42 "Comparison
Functions"
→
page66 "RUN Output"
The input for controlling the hold signal.
→ page46 "Hold Functions"