Showa DS-6200, Operating Manual

Page: 24 / 150

2 INSTALLATION & CONNECTION
23
INSTA
LLATION &
CON
N
ECTION
Chapter
2
How to assemble the connector
1.
Set the connector and screws (two) into the grooves of the case (one side).
2.
Cover with the other case, and fit the cases.
3.
Tighten the M2
×
8 pan-head machine screws (two). Tighten the M2
×
10 pan-head
machine screws (two). Be aware that washers should be set to the M2
×
10 pan-
head machine screws (two).
■
RS-232C interface connection
This connector connects the RS-232C.
Adaptable plug (TCP8080-015267) (manufactured by HOSIDEN or equivalent)
Connector
Pan-head machine screw
M2
× 8 (short) (two)
Nut M2 (four) Pan-head machine screw
M2
×
10 (long) (two)
Washer (two)
Case (two)
Screw (two)
Pin No. Signal name
1 DCD
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
Case F.G
Example of cabling
The following shows an example of connection
between DTE-DTE terminals. This will require
modification depending on the equipment to be
connected. For details, see the operation manual
of the equipment to be connected.
DCD
DSR
RXD
TXD
DTR
GND
RTS
CTS
1
6
2
3
4
5
7
8
4
3
2
1
6
5
8
7
9
DTR
TXD
RXD
DCD
DSR
GND
CTS
RTS
RI
TCP8080-015267 or equivalent D-Sub 9pin
DS-6200 PC etc.
Cabling diagram
* This connection diagram shows cabling
applicable to the case where your PC is DTE
(data terminal equipment).
For connection with DCE (data circuit-
terminating equipment), such as a modem,
use straight type cabling.
* Prepare cabling after reconfirmation of the
connector shape and signal lines (pin
assignments) of the equipment you use.