Shini SG-3650E, Manual

Page: 53 / 56

53(56)
Picture 6-5
：
Lock Screw
6.4.2 Weekly Checking
1) Check if the electric wires are worn out or damaged. Replace the broken
wires.
2) Check the function of safety switch.
3) Check the safety switch of feed box and storage bin.
6.4.3 Monthly Checking
1) Check if the V blet is damaged or not.
2) Check belt tension every 6 months, see details at chapter 6.2
“ Transmission ” .
6.5 Cleaning
Note!
Make sure the main power is turned off before cleaning. When you open
the feeding hopper, becareful not to touch the blades. Sharp blades may
cause personal injuries.
1) Before turning off the machine, please check if the material inlet bin and
cutting chamber is empty.
2) Clean the exterior surface of the feed box.
3) Turn off the main power switch.
4) Clean the baffle plate of the feed box with a dust separator.
5) Loosen the lock screw.
6) Loosen the lockup clip and open the feed box backwardly.
Note!
The feed box is held by pneumatic spring, therefore it can not fall down.
7) Clean the interior surface of the feed box.
8) Remove the regrind storage bin.