SHERCO 250 SEF RACING, Owner'S Manual

Page: 130 / 306

130
ELECTRICAL SYSTEM MAINTENANCE
- Insert the battery into place.
- Connect the positive cable to the battery.
- Connect the negative cable to the battery.
- Install the battery retaining bracket and tighten the
two screws .
- Check the positioning of the battery cables to make
sure that they do not interfere with the installation
of the air filter.
- Replace the air filter (

p.112).
- Replace the seat (

p.112).
The battery is a maintenance-free type. If the vehicle
is not used for an extended period, it is recommended
that the battery be disconnected and stored in a dry
place. See removing the battery (

p.129).
Check the voltage of the battery with a voltmeter:
If the voltage is below the specification, remove the
battery and recharge it using a battery charger.
Factory version need a specific lithium charger.
Disconnect the charger after charging.
Install the battery (

above).
REINSTALLING THE BATTERY
CHARGING THE BATTERY
1
Chassis screws 10Nm M6
Battery voltage
Battery charging
(12V)
>12.5V
0.5 A for 10 hours
or 5A for 30 minutes
1