SHERCO 250 SEF RACING, Owner'S Manual

Page: 126 / 306

126
BRAKES
- The hydraulic fluid is highly corrosive.
- It can be dangerous to the skin.
- Read the recommendations on the container.
- Remove the two screws .
Remove the cover and the membrane .
Fill the tank with brake fluid to the correct level .
- Reinstall the membrane, the cover and the screws.
The position of the brake pedal can be adjusted as
follows: loosen the lock nut loosen or tighten the
screw to obtain the desired position.
Tighten the lock nut when the pedal is properly
located.
Check the pedal travel ( below).
- Remove the spring .
- Operate the pedal several times.
- Replace the spring .
If the travel does not meet the specification, refer to
the rear brake travel adjustment.(

p.127).
WARNING
1
1
A
FILLING THE FRONT BRAKE RESERVOIR WITH BRAKE FLUID
ADJUSTING THE POSITION OF THE REAR BRAKE PEDAL
CHECKING THE TRAVEL OF THE REAR BRAKE PEDAL
Level of brake fluid below the top
of the reservoir.
5mm
Motul
®
RBF 700 brake fluid DOT4
Brake pedal lock nut
Rear brake pedal travel
10Nm M6
≥ 3mm ≥ 5mm
1
2 3
A
1
2
A
2
1
1
2
3
1
A