4-11
VL-E610S/VL-E610H
VL-E660S/VL-E96E
VL-E98E
(2) Rise check
1 Playback the alignment tape (VR2DBOPS).
2 Once eject the cassette, and then load it again.
3 Set the playback mode, and ascertain that the RF waveform rises horizontally within 2 seconds. At this time ascertain
that there is no tape slackness near the pinch roller.
4 After V/S F, R and FF/REW execute playback, and ascertain that the RF waveform rises horizontally within 2
seconds. At this time ascertain that there is no tape slackness near the pinch roller.
Figure 11
(3) Checking the tape travel
1 When the tape is played back, ascertain that tape lift and tape curl of 0.3 mm or more do not occur at the lower flange
of Si roller, upper flange of Sup GR, upper flange of Tu GR, and upper/lower flange of Tu guide.
2 In case of V/S F and R ascertain that no curl is found at each flange.
Figure 12
4-4-7. Checking and adjusting the playback switching point
Refer to the description of playback switching point adjustment in section of VCR circuit adjustment.
Capstan shaft
Tu guide
Tape slackness
Tu GR
Tension pole
Si roller
Sup tilted pole
Sup GR
Drum
Drum
Tu GR
Pinch roller
Tu guide
Tu tilted pole