4-14
VL-E610S/VL-E610H
VL-E660S/VL-E96E
VL-E98E
4-5-2. Cassette control ass’y
<Disassembling>
(1) Set the unit to the EJECT mode, and let the housing stand upright. Or set the unit to the STANDBY mode, press the
lock lever in the arrow direction, and let the housing stand upright. (See Fig 5: in the direction
a
or
b
) (When pushing
in the direction
a
, slightly lift the housing by hand to release the lock lever.)
(2) Remove the four screws
2
and take out the down guide
3
.
(3) Slide the two link support shafts
c
and the two roller shafts
d
to the round openings
g
on their respective slide
chassis slits (two at
e
and two at
f
).
(4) Deflect the roller shafts
d
a little inward to get them out of the round openings
g
on the slide chassis. (Be careful
not to deform the inner links.)
Figure 6.
Lock Lever
Down Guide
c
i
b
j
a
Screw
Figure 5. Lock lever section
Screw tightening
torque (4 locations)
0.069
±
0.007 N·m
(0.7
±
0.07kg·cm)
1
d
c
c
f
m
4
m
l
d
k
n
e
e
2
2
2
2
3
i
i
g
f
g
r
<Reassembling>
(1) Set the unit to the STANDBY mode.
(2) Deflect the roller shafts
d
a little inward, and fit them into the round openings
g
on the slide chassis. (Be careful
not to deform the inner links.)
(3) Align the flanges of roller shafts
d
with the slide chassis slits
f
. While sliding the flanges, fit the support shafts
c
in the slide chassis slits
e
, and slide them until they reach the slits.
(4) Attach the down guide. (While pressing the guide in the direction
i
, tighten the screws until the gap
j
between
the down guide
3
and the support shafts
c
becomes zero.)
Tightening torque: 70
±
7 mN·m (0.7
±
0.07 kg·cm)
