4-4
VL-E610S/VL-E610H
VL-E660S/VL-E96E
VL-E98E
4-2-2. Notes and cautions
(1) Any cut washers, once removed for parts replacement or for other reason, must be replaced with new ones.
(2) The mechanism of this VCR does not involve any volume adjustment. If the specified range is not satisfied, either
cleaning or replacing the parts is required.
(3) Oils
a) Be sure to use the specified oils (different viscosity may cause troubles).
b) For the bearings, be sure to use oil that is free form dust and other foreign substances. (Dust or foreign substance
contained in the oil may cause wear or seizure of the bearings.)
c) A drop of oil represents the amount of oil which is held on the needle top as shown in the figure below.
(4) The circuit repair must be executed without removing the V frame.
(5) For operating the mechanism alone, actuate it with the motor. The terminal-to-terminal voltage must be DC4V or less.
(6) When installing the cassette control, press the part A shown below. Do not press other parts.
(7) Take care so that the whole mechanism is not deformed.
Oil
Diameter
φ
1.5 or less
Figure 1
A
