Sharp PC-9800T, Manual

Page: 48 / 125

2
Installing and Uninstalling the Floppy Disk Drive
After installing or uninstalling the floppy disk drive, you have to change the settings
as follows.
After installing the floppy disk drive:
1.
Turn on the notebook.
2. When the message Press <F2> to enter SETUP appears, press F2 .
3. In the Main menu, set the item of Diskette A: to 1.44 MB, 3 1/2 .
4. Press Esc ; then, Enter twice. The system restarts.
5. From the Start menu, select Settings - Control Panel .
6. Double-click System , and select the Device Manager tab.
7. Double-click Floppy disk controllers .
8. See whether an X mark is attached to Standard Floppy Disk Controller . If the
mark is not attached, the settings are finished. If the mark is attached, go on to
the next step.
9. Double-click Standard Floppy Disk Controller .
10. Uncheck Disable in this hardware profile .
11. Click OK ; then, Yes .
After uninstalling the floppy disk drive:
1.
Turn on the notebook.
2. When the message Press <F2> to enter SETUP appears, press F2 .
3. In the Main menu, set the item of Diskette A: to Not Installed .
4. Press Esc ; then, Enter twice. The system restarts.
Basic Operations 2-9