Sharp AR-F152, Service Manual

Page: 26 / 170

[5]
UNPACKING AND INSTALLATION
1. COPIER INSTALLATION
Improper installation may damage the copier. Please note the
following during initial installation and whenever the copier is
moved.
Caution: If the copier is moved from a cool place to a warm
place, condensation may form inside the copier.
Operation in this condition will cause poor copy
quality and malfunctions. Leave the copier at room
temperature for at least 2 hours before use.
Do not install your copier in areas that are:
●
damp, humid, or very dusty
●
exposed to direct sunlight
●
poorly ventilated
●
subject to extreme temperature or humidity changes, e.g.,
near an air conditioner or heater.
The copier should be installed near an accessible power outlet
for easy connection.
Be sure to connect the power cord only to a power outlet that
meets the specified voltage and current requirements.
Also make certain the outlet is properly grounded.
Be sure to allow the required space around the machine for
servicing and proper ventilation.
2. CAUTIONS ON HANDLING
Be careful in handling the copier as follows to maintain the per-
formance of this copier.
Do not drop the copier, subject it to shock or strike it against
any object.
Do not expose the drum cartridge to direct sunlight.
Doing so will damage the surface (green portion) of the drum
cartridge, causing poor print quality.
Store spare supplies such as drum cartridges and TD
cartridges in a dark place without removing from the package
before use.
If they are exposed to direct sunlight, poor print quality may
result.
Do not touch the surface (green portion) of the drum cartridge.
Doing so will damage the surface of the cartridge, causing poor
print quality.
8"(20cm)
8"(20cm)
4"
(10cm)
4"
(10cm)
AR-F152
5 – 1