Sharp AR-F152, Service Manual

Page: 105 / 170

6 Press FUNCTION to highlight the bit in the cursor
position. SW10 = 10010101
bit # = 12345678
7 Press ENTER to register. SW # = Return to Step 3.
Press STOP to exit from the mode.
(2) Soft switch clear mode
Procedure LCD Operation
1 Press FUNCTION, 9,
∗
, 8, #, 7. DIAGNOSTIC MODE
ROM VERSION = <version>
2 Press ENTER. DIAGNOSTIC MODE
SELECT MENU(
← →
)
3 Press 0, 2. 02:SOFT SW CLEAR
1:OK 2:CANCEL
4 Press 1. DIAGNOSTIC MODE
SELECT MENU(
← →
)
The soft switches setup is reset to the default,
and this mode is terminated.
(3) ROM & RAM check mode
Procedure LCD Operation
1 Press FUNCTION, 9,
∗
, 8, #, 7. DIAGNOSTIC MODE
ROM VERSION = <version>
2 Press ENTER. DIAGNOSTIC MODE
SELECT MENU(
← →
)
3 Press 0, 3. 03:ROM/RAM CHECK
4 (Normal case) ROM/RAM OK
(RAM error) RAM ERROR Two short beeps
(ROM error) ROM ERROR One short beep
(4) Signal send mode
Procedure LCD Operation
1 Press FUNCTION, 9,
∗
, 8, #, 7. DIAGNOSTIC MODE
ROM VERSION = <version>
2 Press ENTER. DIAGNOSTIC MODE
SELECT MENU(
← →
)
3 Press 0, 4. 04:SIGNAL SEND
SELECT SIGNAL
4 Press
←
or
→
repeatedly to select the target
signal.
<signal type>
PRESS ENTER KEY For <signal type>, refer to TABLE-3.
5 When the target signal is displayed, press ENTER. mode # = 1
→
10
mode # = 2
→
20
mode # = 3
∼
6
→
30
mode # = 7
→
40
10 1:NO SIGNAL The relay is turned ON.
11 Press STOP. 04:SIGNAL SEND
SELECT SIGNAL The relay is turned OFF.
“NO SIGNAL” mode is terminated.
12 (To terminate this mode)
Press STOP. This mode is terminated.
20 2:DTMF
DTMF # =
21 Press any NUM key(0
∼
9) or
∗
or #. 2:DTMF
DTMF # = <pressed key> The DTMF signal corresponding to the
pressed key is sent.
22 Press STOP. 2:DTMF
DTMF # =
23 (To continue)
Go to 21.
(To change the signal kind)
Press STOP. 04:SIGNAL SEND
SELECT SIGNAL
(To terminate this mode)
Press STOP twice. This mode is terminated.
AR-F152
9 – 16