Sharp AR-F151, Facsimile Operation Manual

Page: 12 / 77

INITIAL SETTINGS 2-2
STOP
About the Liquid Crystal Display
The unit is equipped with a two-line liquid crystal display (LCD) on the operation panel
for displaying various messages and settings during operation. This LCD can display
up to 20 characters on each line. When the unit is idle, the LCD shows the date, time,
and the stand-by memory available.
Example:
Adjust the volume of both key beeps and alarm beeps (emitted at the end of transmission
and reception) using the procedure below.
Factory setting: 3 (MEDIUM)
Step Press these keys Comments
1
“OPTION SETTING” will appear in
the display.
2
“BEEP VOLUME” will appear in the
display.
3
Press the or key to lower or raise
the volume to the desired level.
4
“STORED” will appear in the display.
5
Press the STOP key twice to exit.
FUNCTION
GHI
MNO
or
ENTER
STOP
Adjusting the Beep Volume
The left and right arrow ( ) keys on the operation panel of the unit are very useful
for scrolling through the various function lists and settings. Once you have pressed the
FUNCTION key, you can scroll through the ten functions as desired. (See the Function
mode at the top of the Quick Reference Guide for the settings.) Pressing the ENTER
key chooses the displayed function. For many of the function lists, you can then use the
arrow keys again to scroll through the settings.
Using the Arrow Keys
Located to the upper right of the operation panel, the LCD contrast dial controls the
contrast of the display.
Turning the dial to the right darkens the LCD. Turning the dial to the left lightens the
LCD.
02_INITAL.p65 3/22/00, 2:39 PM 2