Seypos DT6800, Configuration Manual

Page: 20 / 165

15
STOP BIT SELECT
The stop bit(s) at the end of each transmitted character marks the end of
transmission of one character and prepares the receiving device for the next
character in the serial data stream. The number of stop bits selected (one or
two) depends on the number the receiving terminal is programmed to
accommodate. Set the number of stop bits to match host device requirements.
< 1 Stop Bit >
2 Stop Bits
DATA BITS
This parameter allows the decoder to interface with devices requiring a 7-bit or
8-bit ASCII protocol.
7-Bit
< 8-Bit >