SEW-Eurodrive EDR200, Operating Instructions Manual, Page: 17 / 272

3
Motor structure
Basic structure of EDR..71 – 132, EDRN71 – 132S motors
Operating Instructions – EDR..71 – 315, EDRN63 – 315
17
3.2 Basic structure of EDR..71 – 132, EDRN71 – 132S motors
The following figure shows an example of the basic structure of EDR..71 – 132,
EDRN71 – 132S motors with cage clamp:
[117]
[118]
[116]
[119]
[122]
[123]
[132]
[131]
[137]
[262]
[616]
[124]
[129] [134]
[148]
[112]
[111]
[454]
[113]
[452]
[128]
[140]
[139]
[106]
[107]
[103]
[93]
[9]
[7]
[12]
[1480]
[109]
[108]
[24]
[16] [41] [22]
[13]
[42]
[30]
[35]
[706]
[715]
[705]
[716]
[707]
[100]
[90]
[2]
[10]
[11]
[3]
[36]
[44]
[32]
[1]
[90]
[91]
[93]
9007202186626955
[1] Rotor [36] Fan [113] Pan head screw [139] Hex head screw
[2] Retaining ring [41] Equalizing ring [116] Retaining clip [140] Lock washer
[3] Key [42] B-side endshield [117] Hex head screw [148] Retaining clip
[7] Flanged endshield [44] Deep groove ball bearing [118] Lock washer [262] Terminal
[9] Screw plug [90] Bed plate [119] Pan head screw [392] Gasket
[10] Retaining ring [91] Hex nut [122] Tooth lock washer [452] Terminal strip
[11] Deep groove ball bearing [93] Countersunk screw [123] Hex head screw [454] Support rail
[12] Retaining ring [100] Hex nut [124] Tooth lock washer [616] Retaining plate
[13] Cap screw [103] Stud [128] Retaining clip [705] Canopy
[16] Stator [106] Oil seal [129] Screw plug [706] Spacer
[22] Hex head screw [107] Oil flinger [131] Gasket for cover [707] Pan head screw
[24] Lifting eyebolt [108] Nameplate [132] Terminal box cover [715] Blind rivet
[30] Oil seal [109] Grooved pin [134] Screw plug [716] Washer
[32] Retaining ring [111] Gasket for lower part [137] Screw [1480] O-ring
[35] Fan guard [112] Terminal box lower part
25896334/EN – 06/2019