Change Network
You radio may be customised to use other networks when you move into
their coverage area.
To change network
1. Select
Menu > Networks > Change Network
.
2. Navigate to the required network then press
Select
or the Select/Send key.
Tip:
To select the local network automatically, select the Automatic check
box. (Pressing the Cancel/Home key does not deselect a network.)
Transmit Inhibit
Sometimes you may be working in areas that are sensitive to Radio Frequency
(RF) signals such as healthcare facilities. To continue operating your radio in
these areas, you can set your radio to Transmit Inhibit mode to prevent any
RF transmission.
When Transmit Inhibit is activated or deactivated, a status message is sent
confirming the operational state of your radio. You cannot activate Transmit
Inhibit when you are in a call.
Caution:
Alarm Calls initiated in Transmit Inhibit mode are still
transmitted.
Note:
You cannot select Transmit Inhibit if user profile
Do Not Disturb
is
selected. See
.
Note:
Your radio automatically leaves Transmit Inhibit mode when you
power it off; when powered on again Transmit Inhibit is not activated.
To activate or deactivate Transmit Inhibit mode
1. Select
Menu > Networks > Transmit Inhibit
.
2. Select
Toggle
to toggle Transmit Inhibit on/off.
When Transmit Inhibit mode is activated:
User Guide
85