To initiate a Quick Call
1. Press a pre-configured soft key.
2. Press the
PTT
to transmit.
Depending on the configuration this causes all or some of the following to
happen:
if your radio is in Smart Call Mode it reverts to Group or Individual Mode
(see
).
your radio sets up a voice call to a programmed recipient which can be
individual or talkgroup
your radio sends up to two Status messages
your radio sends a position report
Note:
Quick Calls cannot be made from a radio in Gateway Mode. Switch
your radio to TMO or DMO before making a Quick Call. See
Note:
Quick Calls cannot be made from a radio which is making or
receiving an emergency call or if your radio is in Transmit Inhibit mode.
See
and
.
Smart Calls
A
Smart Call
is a high priority group or broadcast call to a specific talkgroup.
This can be useful , for example, where you need to make an announcement
to everyone in the vicinity of an incident, not just those in your selected
talkgroup.
The radio supports two separate
Smart Call Modes
(A and B) associated special
folders
Smart Call 1
and
Smart Call 2
respectively. Each Smart Call Folder can
be pre-configured with up to 75 talkgroups.
You initiate a Smart Call by switching to Smart Call mode, then you press the
PTT to transmit to a chosen talkgroup in the Smart Call Folder.
Note:
Broadcast calls cannot be made from a radio which is in DMO.
Attempting to make a Smart Call in DMO initiates a group call to the
attached talkgroup.
68
SC20 series – 04/2016