The AWM 2 antenna wall mount
175
▷
Do not kink the antenna cables and, when running the cables, make
sure not to bend them beyond a bend radius of 43 mm.
▷
Smaller bend radiuses can cause cracks and breaks in the cable, which
may not be visible from the outside. This can result in bad reception
quality.
▷
Screw the sockets to the antenna holes using the supplied washers and
nuts.
▷
Screw the cover back to the antenna housing. Observe correct cable
routing.
▷
Connect the two rod antennas of the antenna wall mount to the R-SMA
sockets.
▷
Use the elongated mounting holes to mount the antenna wall mount to
a wall or screw the antenna wall mount onto a microphone stand with
a 3/8" thread.
The antenna cables can be run from the rear panel of the antenna hous-
ing directly trough a wall. When wall mounting the antenna wall mount,
observe a minimum distance of 160 mm between the top of the antenna
wall mount and the ceiling.
▷
If necessary, connect extension cables to the R-SMA sockets of the an-
tenna wall mount.
▷
Connect the R-SMA connectors to the R-SMA sockets of the receiver.
You can find additional information on possible setups using the
AWM 2 and general recommendations on antenna usage under „Rec-
ommendations on antenna mounting“.
