Performing a walk test (reception quality)
141
▷
Click
Stop
to end the walk test.
If the result of the walk test is not satisfying, you can take the following re-
medial measures:
•
If possible, position the receiver so that there is always a direct line of
sight between the receiver and the paired transmitter.
•
If possible, remove obstacles between the transmitter and the receiver.
•
If necessary, adjust the manually selected transmission power in the
Control Cockpit
under
RF power mode
on the
RF settings
tab. You can
find more information under „Multi-room mode“.
Performing a walk test with the SL Rack Receiver DW in the Control
Cockpit
To perform a walk test in the
Control Cockpit
:
▷
Switch on the transmitter and the receiver of the radio link you want to
check.
▷
In addition, switch on all other devices that you want to use in the op-
erating environment.
▷
Select the device in the
Control Cockpit
.
▷
Open the
RF settings
tab.
►
▷
Click
Start
under
Walk test
.
►
▷
Walk the operating environment with the transmitter.
The display of the radio signal level is continuously updated.
▷
Click
Stop
to end the walk test.
If the result of the walk test is not satisfying, you can take the following re-
medial measures:
