Sena Parani10, User Manual

Page: 37 / 46

37
S-register command: If you change the values of S-register, please reboot Parani10.
ATSnn=mm<cr>: To change ATSnn register value
ATSnn?: To check current ATSnn register value.
29)
ATS3 Stream UART policy (Default 0)
If set as ‘0’, throughput is the priority, if set as ‘1’, Latency
is the priority.
30)
ATS4 Enable Remote name query (default 1)
Get BDaddress and device name during Inquiry.
If set as ‘0’, only get BD address. Inquiry time can be
faster.
31)
ATS10 Default 1
ATS10=1<cr> :
Enabling all of the response messages- OK, CONNECT,
DISCONNECT, and ERROR.
ATS10=0<cr> :
Disabling all of the response messages- OK, CONNECT,
DISCONNECT, and ERROR.
ATS10?<cr> : To see current status of ATS10
32)
ATS11 Enable Escape (default 1)
Escape sequence character enable change from on-line
mode to command mode. If set to ‘0’, transmission speed
can be improved.
33)
ATS12 Clear UART buffer at Disconnect. (default 0)
If set to ‘1’, when disconnected, data stored in Parani10
will be removed.
34)
ATS13 Enable CDC accept (default 0)
If set to ‘0’, Parani10 will use CDC signal to let Host know
Bluetooth connection status.
If set to ‘1’, Parani10 will accept CDC signal from other
peer (DCE-configured) Bluetooth device.
35)
ATS14 ATS14=1<cr>: Users may use DTR/DSR lines for
communications
ATS14=0<cr>: Users may use DTR/DSR lines for Loop-
back only.
Default value of ATS14 is 0.