24
their counterpart in their internal Flash. When desired, release the
connection as directed in section 3.2.4.
4. Set the operating mode of one Parani10 to MODE 1 by entering an ‘AT+
BTMODE’ command as shown below.
5. Set the operating mode of the other Parani10 to MODE 2 by entering an
‘AT+BTMODE’ command as show below.
6. Turn both Parani10 units power off. The Parani10 pair will connect
automatically when they are powered up again.
7. To release this paring, set them to MODE 0 by entering ‘AT+BTMODE, 0’. or
reset the units by pressing the RESET button.
3.2.6 AT command vs. Operational Status
The AT command sets listed above can be executed per Parani10 operational status. The
following table shows the operational status and executable AT command sets.
AT+BTMODE,0
OK
AT+BTCANCEL
OK
AT+BTMODE,2
OK
AT+BTMODE,1
OK
Summary of Contents for Parani10
Page 1: ...1 Parani10 Enabling Wireless Serial Communication Users Guide Version 1 0 0 2005 03 07...
Page 3: ...3 Revision History Revision Date Name Description V1 0 0 2005 03 02 D H Shin Initial Release...
Page 7: ...7 Fig 1 2 1 DC Power Cable Red colored wire of DC power cable is for...
Page 41: ...41 HIGHT 35 mm 3 2 OUTPUT CABLE CABLE LENGTH 1850 50...
