ENFORCER Fingerprint Reader and Keypad
6
SECO-LARM U.S.A., Inc.
1.
Find a suitable location to mount the fingerprint
reader/keypad. Install it at a height at which most users
will be able to easily operate the unit.
2.
Using the included security wrench, unscrew the
security screws located on the bottom of the fingerprint
reader/keypad (Fig. 1).
3.
Carefully remove the fingerprint reader/keypad from
the housing base, sliding the keypad slightly upwards.
4.
Using the housing base as a template, mark the holes
needed for the wiring and mounting screws and drill
needed holes. Ensure that the wiring hole is large
enough to allow the wiring to be pushed in without
crimping.
5.
Run wiring through the wall to the wiring hole cut in the
wall
6.
Thread the wiring through the center of the fingerprint
reader/keypad's base.
7.
Install the base using the included mounting screws
and mounting screw anchors (if necessary). Ensure the
correct orientation as shown in Fig. 2.
8.
Connect the wires to the fingerprint reader/keypad
according to "Wiring Chart" below.
9.
Finish assembly by reattaching the fingerprint
reader/keypad to the base and securing with the
security screw.
Wiring Chart:
Connection Wires
Color
Function
Description
Red
Power (+)
Connect to +12VDC power supply
Black
Ground (-)
Connect to Ground
Yellow
Egress Input
N.O. Pushbutton contact to ground. Press button to
activate the output
Brown
Door Sensor
Connect to a magnetic contact or door sensor
Blue
Output N.O.
NO/NC/COM, relay output, max. 2A@12VDC
Purple
Output COM
Orange
Output N.C.
Gray
Alarm Output
Transistor ground output, max. 2.5A@12VDC. Switches to
ground (-) when tamper switch activated.
Green
Data 0
Wiegand controller
White
Data 1
Wiegand controller
Installation:
Fig. 2
Fig. 1
Drill 2 mounting holes
3
1
/
4
" (83mm) apart
Drill at least ø
3
/
8
"
(ø9mm) wiring hole
NOTE:
For weatherproof installation, add a
bead of silicone sealant around the
base where it meets the wall.
