ENFORCER Fingerprint Reader and Keypad
SECO-LARM U.S.A., Inc.
5
Status
Sounds
LED
In standby mode
--
Red steady
In base programming mode
1 Beep
Red flashing
In function programming mode
1 Beep
Orange steady
Exit programming mode
1 Beep
Red steady
Successful operation
1 Beep
Green steady
Unsuccessful operation
3 Fast beeps
Notification output
Rapid beeping*
Red flashing rapidly
LED Indicators and Device Sounds:
*De-activate the notification or alarm by presenting a valid user fingerprint or by entering a valid user code.
Important Notes:
1.
Always disconnect power before servicing the fingerprint reader/keypad. Do not apply power
until all connection wiring is completed.
2.
The fingerprint reader/keypad must be properly grounded. Use a minimum 22AWG wire
connected to the common ground wire. Failure to do so may damage the unit.
3.
All wiring and programming should be done by a professional installer to reduce the risk of
improper installation.
4.
The user's operating guide for this fingerprint reader/keypad is located on pg. 27 of this
manual. Be sure to store this manual in a safe place for future reference.
Parts List:
1x Fingerprint reader and keypad
1x Security wrench
1x Diode
2x Mounting screws
2x Mounting screw anchors
1x Manual
Overview:
1
"
(26mm)
IF USING THE FINGERPRINT READER/KEYPAD WITH A
MECHANICALLY OPERATED DOOR OR GATE, MOUNT THE UNIT AT
LEAST 15' (5m) FROM THE DOOR OR GATE TO PREVENT USERS
FROM BEING CRUSHED OR PINNED. FAILURE TO DO SO MAY
RESULT IN SERIOUS INJURY OR DEATH.
!
!
5
3
/
8
"
(137mm)
2
1
/
4
"
(58mm)
33
7
/
16
"
(850mm
)
