ENFORCER Fingerprint Reader and Keypad
2
SECO-LARM U.S.A., Inc.
This page is for installers looking to do a basic installation and programming of the fingerprint
reader and keypad. For more in-depth installation and programming instructions, see "Table of
Contents" on pg. 4.
Quick Wiring Diagram:
Mounting Diagram:
NOTE:
For DC-powered electric strikes, connect the included diode as close as possible and in parallel
with the electric strike. This absorbs possible electromagnetic interference to prevent operation
of the strike from damaging the fingerprint reader/keypad. Do not connect a diode when using
electromagnetic locks or with AC powered strikes.
Quick Installation Guide:
Orange – Output (N.C.)
Blue – Output (N.O.)
Yellow – Egress Input (N.O.)
Black – Ground (–)
Gray – Tamper Alarm Output (GND)
Purple – Output (COM)
Red – 12VDC (+)
12VDC
Power
Supply
(+)
Egress
Button
(–)
(+)
(–)
Or
Cathode
Electric
Lock
IN4007
Output Relay
N.O. Output for Fail-secure Lock
N.C. Output for Fail-safe Lock
(+)
Alarm
(–)
Diode IN4007
(See note below)
Door Sensor
Brown – Door Sensor Input
Green – Data 0
White – Data 1
Wiegand
Controller
Mounting screws
Housing base
Security screw
Drill 2 mounting holes
3
1
/
4
" (83mm) apart
Drill at least ø
3
/
8
"
(ø9mm) wiring hole
