ENFORCER Fingerprint Reader and Keypad
SECO-LARM U.S.A., Inc.
3
Quick Programming Guide:
Programming Tips:
•
Master programming code (6 digits) should be programmed before any other programming.
•
A steady red LED indicates that fingerprint reader/keypad is in standby mode. A flashing red
LED indicates that fingerprint reader/keypad is in base programming mode. A steady orange
LED indicates the unit is in function programming mode.
Programming Instructions:
Follow the instructions below if the following covers your needs:
•
A new master programming code.
•
Setting one user fingerprint and one user code.
•
A door-unlocked time of 3-seconds after the output is activated.
1.
Enter programming mode:
NOTE:
is the factory default master programming code. A new master
programming code (6 digits) should be set the first time you enter programming mode. There is
no master programming fingerprint.
2.
Set the master programming code (6 digits):
NOTE:
is the new master programming code and must be entered twice.
3.
Set a user fingerprint to operate the output (unlock the door):
NOTES:
•
chooses fingerprint user ID #3 of 998 possible fingerprint users (1~998).
(Omit
to use auto ID to assign the first available user ID.)
•
is the new user fingerprint (must be presented twice to set).
4.
Set a user code to operate the output (unlock the door):
NOTES:
•
chooses user code ID #1001 of 2998 possible user codes
(1001~2998).
•
is the new user code for user ID #1001 (4~6 digits).
5.
Set the output time (skip this step if the default value of 5 seconds is acceptable):
NOTE:
sets the output delay time for 3 seconds.
6.
Exit programming mode:
