ENFORCER Fingerprint Reader and Keypad
12
SECO-LARM U.S.A., Inc.
Programming User Fingerprints (Continued):
With Specific ID:
Specific ID allows the programmer to assign the user fingerprint to a particular fingerprint user ID
(any unused fingerprint user ID between 1 and 998 for common users; 999 or 1000 for super user
fingerprints). When programming user fingerprints with specific ID, use the following formula after
entering programming mode (see "Enter and Exit Base Programming Mode," pg. 9):
– After a short beep, you may continue to add users by repeating
these steps, but without repeating the function code
.
– Add Users function code (LED will change to steady orange)
–
to
– 998 unique fingerprint user IDs for user fingerprints to trigger the device
(and 2 super user IDs for super user fingerprints to toggle between disable and enable user
access)
– User’s fingerprint
NOTES:
•
Entering a User ID followed by the
key allows the programmer to assign a particular
fingerprint user ID to the subsequent user fingerprint. If this step is omitted, the fingerprint
reader/keypad will automatically assign the user fingerprint to the first available user ID.
•
Each user ID must be unique and cannot be repeated for multiple user fingerprints or codes.
•
represents the user fingerprint, which must be presented twice. The unit will beep once
and the LED will flash green once to indicate that the fingerprints were read successfully.
•
Additional users may be entered in succession without repeating the function code
.
•
To return to base programming mode to program other functions, press the
key (the LED
will flash red) followed by the function code for that function (LED becomes steady orange).
•
Exit programming mode by pressing the
key after all programming is completed. One beep
will sound and the LED will return to steady red. After 25 seconds of inactivity, the keypad will
automatically exit programming mode and return to standby.
Examples for the Above Methods:
1.
Program a user fingerprint for User ID #10:
2.
Program two user fingerprints for User IDs #15 and #17
(1
st
user) wait for beep, then
(2
nd
user)
3.
Program a user fingerprint to an automatically assigned User ID (generally not recommended, since
the User ID will be needed to delete a user when their fingerprint is not available):
– In this example, the reader/keypad will assign the next available User ID
