SealMaster CRACK PRO 125, Owner'S Manual

Page: 17 / 74

17
CRACK PRO® HEATED HOSE MACHINE
OPERATING INSTRUCTIONS
FLUID SPECIFICATIONS
Heat Transfer Oil:
Heat transfer oil is specially formulated to withstand high temperature and many
heating and cooling cycles. The normal life cycle is one to two years, depending
on how much the machine is used.
Never leave the oil in the machine for more than two years.
The procedure for checking the oil level is to
ALWAYS CHECK IT COLD .
Located on the expansion tank is an oil level dip stick, there is a mark on the dip
stick to designate the full point. When adding oil, it is necessary to remove the oil
thermometer from the top rear curbside corner. Install a funnel here, and check
with the dip stick.
Heat Transfer Oil Gallons per Tank:
Tank Size Gallons
125 25
200 28
260 30
400 45
DO NOT OVERFILL, OVER FILLING WILL CAUSE OIL TO COME OUT THE OVERFLOW
VENT PIPE AND ONTO THE GROUND WHEN THE MACHINE IS BEING HEATED
Oil coming out of the vent pipe means one of two reasons, overfilling or moisture
is present in the oil jacket.
Immediately shut off the burner if this happens. Let the machine cool
completely.
Water in the oil is
extremely dangerous . Never heat the machine if water is
present. Drain and replace.
The factory installed oil meets the following specifications:
Name
Industrial turbine oil
Flashpoint >390°F
Auto-ignition temp. >500°F
Factory installed oil: Turbine XL 68 See enclosed MSDS