5
| P
age 42 | SEABOB Operator's Manual |
Never run the motor out of the water
for longer than approx. 10 seconds. The seals of the mo-
tor and the hard-coated motor shaft are designed exclu-
sively for use in the water. Operation out of the water can
lead to overheating due to the lack of water to cool the
device, thereby causing irreparable damage to the seals
and motor shaft. Danger of short circuit!
7. After a successful function check, tap the red button
on the left Control Grip once, until the power is dis-
played as "0 %" again.
8. Lift the SEABOB by the carrying handles on each side,
and place it in water that is at least 1 m / 3.5 ft deep.
Only bring the SEABOB into the water when the power is
displayed as "0 %" to prevent activation of the motor by
pushing the Trigger inadvertently.
Never carry the SEABOB by the Control Grips, front
bumper or display panel. Carry only by the carrying han-
dles on each side.
9. The SEABOB is now ready for operation.
If you are launching the SEABOB from a boat, always
have another person assist with placing the SEABOB
into and removing it from the water (in particular, when
there are waves present). Ensure that no one is under the
SEABOB. Danger of injury!
5.4 Before starting
Switch on the SEABOB.
We recommend that you switch on the SEABOB and per-
form a brief function check before you place the craft in
the water. To do this, proceed as follows:
1. Tap the blue button.
2. The display is switched on. The SEABOB logo and the
prompt "push trigger" appear.
3. Push the Trigger against the Control Grip (within
5 seconds). The SEABOB logo disappears again.
Tip:
If the Trigger is not activated within 5 seconds after
tapping the blue button during activation, the display
will switch off again (device reverts to the Sleep mode).
4. Release the Trigger completely. The User-PIN or Own-
er-PIN prompt will appear (if activated). If the PIN
prompt has been deactivated, the Information Display
will appear directly.
Tip:
If you want to activate the PIN prompt when switch-
ing on the device, or if you want to activate and change
the User-PIN, proceed as described in Chapter 5.3.11
"Settings".
Tip
: After a prolonged phase of being idle, the system
will automatically start the motor initialization. The mo-
tor will make two slow turns. The initialization takes
about 5 seconds.
5. The power is displayed as "0 %" on the power dis-
play. Tap the green button on the right Control Grip
once. When you tap the button, the power shown on
the display increases to Power Level 1 (25 % of en-
gine power).
6. Push the Trigger against the Control Grip and hold it
there for a brief function check (less than 1 second).
The motor starts.
