5
| P
age 33 | SEABOB Operator's Manual |
Time Display:
Tap the blue button on the left Control Grip while the
power is displayed as "0 %" on the power display. The
time display appears.
The operating time of the SEABOB in the On mode ("on
mode") is shown in the center of the display in the fol-
lowing order:
• Operating time during the last operation ("last")
• Operating time during the current day ("day")
• Total operating time ("total")
Tip:
The operating time during the last operation ("last")
shows the operating time of the SEABOB from the last
time it was switched on (On mode) until it was last
switched off (Sleep mode / Off mode).
Tip:
In order to guarantee the operating time during
the current day ("day") is measured accurately, please
always ensure that the stored time is adjusted to the cur-
rent local time. The operating time during the current day
("day") shown on the display is reset daily at midnight.
In order to exit the time display, tap the blue button
again. The Information Display appears on the SEABOB
display.
Timer:
To call up the timer display, set the power display to at
least "25 %" power (Power Level 1). Then type the key
combination blue-blue in rapid succession. The timer dis-
play appears.
The speed range as well as the set maximum power
(Power Level) (marked in red) are shown as before in the
middle field of the display on the outer circle. The follow-
ing information is displayed inside as an alternative to
the Information Display:
• Current power in 4 Power Levels ("power level")
In the time display underneath, 2 possible displays are
differentiated:
• Timer deactivated (0:00 h); Factory distribution:
Display "on mode":
Operating time since activation (in hr: min'sec).
The timer only counts when the engine is running.
Time Display
