5
| P
age 35 | SEABOB Operator's Manual |
5.3.6 Sleep mode / On mode – switching
on / off
The display and motor are switched off in the Sleep mode.
Switching on from the Sleep mode:
1. Tap the blue button.
2. The display turns on. The SEABOB logo and the
prompt "push trigger" appear.
3. Push the Trigger against the Control Grip (within 5
seconds). The SEABOB logo disappears again.
4. Release the Trigger completely. The User-PIN or Own-
er-PIN prompt will appear in the display (if activated).
If the PIN prompt has been deactivated, the Informa-
tion Display will appear directly.
Tip
: After a prolonged phase of being idle, the system
will automatically start the motor initialization. The mo-
tor will make two slow turns. The initialization takes
about 5 seconds.
5. The motor is switched on by pushing the Trigger (the
motor runs with a minimum power of Power Level 1).
Tip:
If the Trigger is not activated within 5 seconds after
tapping the blue button during activation, the display
will switch off again (device reverts to the Sleep mode).
Tip:
If you want to activate the PIN prompt when switch-
ing on the device, or if you want to activate and change
the User-PIN, proceed as described in Chapter 5.3.11
"Settings".
For this reason, you should follow the instruc-
tions given in Chapter 5.10 "Storing the SEABOB"
and Chapter 5.11 "Air transport / transport of the
SEABOB" for correctly powering down the device
to the Off mode for air transport and storage.
Tip:
If the battery charge state is too high prior to
starting the partial charging process for air transport /
transport, you will have to perform an automatic dis-
charge by means of a connected and active charger (may
take up to 24 hours) or by running the SEABOB to empty
in a controlled fashion as described in Chapter 5.11.
Switching on from the Off mode:
When the system is in the Off mode, it can only be
switched back on by initiating the charging process.
1. Plug the connector into the connection port on the
SEABOB.
2. Insert the power plug into the outlet.
3. Activation of the SEABOB is triggered by the inde-
pendent electronic control system in the batteries
together with a correctly detected charger (system
check).
4. The charge display will appear in the display. The
SEABOB is now in the Charge mode.
5. Use the green or red buttons to select the desired
charging option (see Chapter 5.3.7 "Charge mode"
and Chapter 5.3.8 "Charge display").
