5
| P
age 49 | SEABOB Operator's Manual |
When cleaning the SEABOB, never
stand it upright on the front bumper or on the water out-
let of the jet channel. The SEABOB could tip over and
be damaged or damage other objects. Furthermore, this
could prove to be dangerous for any persons in close
proximity.
4. Slightly tilt the SEABOB to ease the cleaning process.
After using the device, first remove salt deposits, dirt
or other foreign objects by rinsing the components
with fresh water (from a low-pressure source such
as a garden hose or watering can) and / or blowing
them out with air from a low-pressure hose. Ensure
that places which are not easily accessible (e.g. water
inlets and outlets) are rinsed thoroughly or blown out
with air.
5. Clean the SEABOB using a soft, clean cloth. If neces-
sary, you can also use a mild cleaning agent designed
for plastic surfaces that will not damage the finish.
Dirt or salt deposits can corrode the sealing surface of
the SEABOB. Even minute damage or dirt on the sealing
surfaces can reduce the effectiveness of the seal, result-
ing in damage to the SEABOB as well as damage to the
motor and the motor‘s electronic system.
Please also ensure that you always follow the further
instructions on cleaning the SEABOB in Chapter 6.1
"Cleaning the SEABOB".
6. Charge the SEABOB after each use (within 24 hours)
to at least the charge state "Air Transport / Storage"
to prevent total discharge of the SEABOB. Be sure
to read the information provided in this Operator's
Manual on charging the SEABOB (see Chapter 5.2
"Charging the SEABOB").
5.9 Switching off the SEABOB to the
Sleep mode
Manual switching off to the Sleep mode:
1. The Information Display is shown in the display. The
power is displayed as "0 %" in the power display.
2. Tap the button combination silver – blue in quick suc-
cession. The prompt "sleep mode - confirm with trig-
ger" appears.
3. If the user activates the Trigger within 5 seconds, the
system will switch to the Sleep mode and switch off.
Tip:
If the Trigger is not activated within 5 seconds, the
system will return to the last selected mode (e.g. Infor-
mation Display in the On mode).
Automatic switch-off (Time-off):
If the user does not activate a button or the Trigger within
10 minutes (Time-off), the system switches off automati-
cally to the Sleep mode.
To switch the device back on from the Sleep mode, see
Chapter 5.3.6 "Sleep mode / On mode".
Tip:
When the SEABOB is completely discharged / run to
empty, the device and the display switch off completely
(Off mode). The SEABOB can only be switched on from
the Off mode using a connected and active charger.
Charge the SEABOB immediately (within 24 hours) to at
least the charge state "Air Transport / Storage" to avoid
irreparable total discharge of the valuable Lithium-Ion
batteries.
