40
The dipstick indicates the amount of
oil to be added in the reservoir. Oil lev-
el should be maintained between
FULL and ADD marks. Before check-
ing oil level, place the watercraft level,
then wipe the dipstick and insert it in
the reservoir neck. Do not screw cap.
Remove dipstick and read the level.
To add injection oil in the reservoir, un-
screw the cap counterclockwise. Fully
tighten when finished.
NOTE:
On the GTX model, stor-
age cover must be opened to ex-
pose oil cap.
HX/XP Models
Hood must be opened to expose oil
cap.
29) Tool Kit
Contains tools needed to perform ba-
sic watercraft maintenance.
30) Storage Compartment
Cover Hinge/Locking
Mechanism
Hinge is provided with a locking mech-
anism to hold storage compartment
cover when fully open. To close cover,
pull side pins.
31) Fuel Tank Cap
Unscrew the cap counterclockwise to
allow fuel tank filling. Fully tighten
when finished.
32) Jet Pump Water Intake
The water is drawn up by the impeller
through this opening. The impeller and
the drive shaft are protected by a
grate.
33) Rear Vent Grills
(GTS Models)
Allows air to get in or out depending
on engine operation.
34) Selector Lever
(GTS Model)
When pushed in, the watercraft is in
forward. To obtain neutral, unlock le-
ver by turning it counterclockwise,
then pull lever until neutral mark ap-
pears on rod. To engage reverse, re-
peat same procedure as for neutral,
but pull lever until reverse mark ap-
pears on rod. Lever locks in forward
and in neutral positions only.
35) Rear Seat Latch (GTX)
Removing the rear seat allows access
to the rear storage tray. It also gives
access to the seat latch of the front
seat.
36) Rear Storage Tray
(GTI/GTX)
A convenient watertight, removable
tray to carry personal articles.
37) Glove Box (GTI/GTX)
A small, convenient watertight stor-
age compartment for keys, wallet,
maps, etc.
◆
WARNING
Never use a lit match or open
flame to check fuel level.
'
-
CAUTION
If grills are kept below water level
for a long period (e.g.: when
boarding 2 passengers) water
will enter the bilge.
◆
WARNING
Selector lever should only be
used when the engine is idling
and craft is completely stopped.
Ensure lever is pushed in and
locked. Do not use as a grab handle.
smo9701a.bk : smo9701b.fm5 Page 40 Monday, November 3, 1997 9:54 AM
www.SeaDooManuals.net
Summary of Contents for 1997 GS
Page 1: ...www SeaDooManuals net ...
