Repeat this action to change the FEC Rate. The selected FEC Rate must match the
FEC Rate associated with the transmitted signal. If you are unsure about which
FEC rate to use, contact your dealer/reseller, or local service provider.
To set the Symbol Rate
Step 1. Be sure you have configured the Local Oscillator and Crossover frequencies as
described above
Step 2. Move to Symbol Rate and press SELECT to replace the current setting.
Step 3. Enter a valid Symbol Rate using the numbered Remote Control buttons and
then press SELECT. You can also press the Ï/Ð arrow buttons to display
available settings (Symbol Rates are displayed from 3 MS/s through 30.8000
MS/s in 10 KS/s steps). The default setting is 28.3465 MS/s.
Step 4. When the desired setting is displayed on-screen, move to Exit and press
SELECT, or press 1 and then press SELECT to change the current setting.
A pop-up menu displays Save options.
Step 5. Press 1 to save the new setting (YES), or follow the on-screen instructions, as
required.
Available options:
Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change to another Symbol Rate. The selected Symbol Rate
must match the Symbol Rate associated with the transmitted signal. If you are un-
sure about which Symbol Rate to use, contact your dealer/reseller, or local service
provider.
To set the Network ID
Step 1. Be sure you have configured the Local Oscillator and Crossover frequencies as
described above
Step 2. Enter a valid Network ID (number) and then press SELECT. You can also press
the Ï/Ð arrow buttons to display available settings (numbers are displayed
from 0 through 65535).
Step 3. When the desired setting is displayed on-screen, move to Exit and press
SELECT, or press 1 and then press SELECT to change the current setting.
A pop-up menu displays Save options.
Step 4. Press 1 to save the new setting (YES), or follow the on-screen instructions, as
required.
Available options:
Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change the Network ID (see also “
…
About the Network ID”).
Changing the Network ID is normally required only when authorized subscriber
services are changed, or when new or different subscriber services are made avail-
able (see Figure 12). If you are unsure about which Network ID to use, contact your
dealer/reseller, or local service provider. Changing the Network ID may also re-
quire that you execute a signal search (see “Search Setup menu”
and “…About the
Find option”).
To set the NIT
NIT (Network Information Table) contains lists of channels and frequency plans
used on the network. The NIT is transmitted from the uplink. In most cases, the
NIT is needed and, therefore, the YES option should be selected. To find out
whether or not you should use the NIT on your receiver, contact your service pro-
vider.
Step 1. Be sure you have configured the Local Oscillator and Crossover frequencies as
described above.
Step 2. Move to Use NIT and press SELECT to switch between YES and NO.
Step 3. When the desired setting is displayed on-screen, move to Exit and press
SELECT, or press 1 and then press SELECT to change the current setting.
A pop-up menu displays Save options.
Step 4. Press 1 to save the new setting (YES), or follow the on-screen instructions, as
required.
Available options:
Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
To set or change the Preset Number
Step 1. Be sure you have configured the Local Oscillator and Crossover frequencies as
described above.
Step 2. Move to Preset Number and press SELECT to clear the current setting.
