&URVVRYHUIUHTXHQF\
The Crossover frequency option is an Alt-2 Mode function. The Crossover fre-
quency is an internal threshold frequency used for selecting the L-Band 1 or
L-Band 2 frequency, depending on the current Downlink and L-Band frequency
settings. The Crossover frequency is valid only if the Frequency Mode is set to
Downlink (dnLn). If you are unsure about which Crossover Frequency to use,
contact your dealer/reseller, or local service provider.
To display or change the Crossover Frequency
Perform the first step if you are changing the Crossover Frequency.
Step 1. If required, press 0 and then press SELECT to display the Installer Channel.
Step 2. Press ALT twice to change from normal operation to Alt-2 Mode.
The ALT LED is ON.
Step 3. Press 8 (XOVER) to display the current Crossover frequency. Pressing the
Ï/Ð arrow button displays higher or lower frequency settings (frequencies
are displayed from 0 GHz through 15 GHz). The default setting is 11.700 GHz.
Step 4. When the desired setting is displayed on-screen, press SELECT to change the
current setting.
The front panel displays sav?.
Available options:
Press 1 to save the new setting (donE), or press 2 to discard all
changes (rstr), or press 3 to cancel the operation (abrt).
Repeat this action to change to another frequency. You use the left
Í
or right
Î
arrow button to change from low to high resolution. Note that when displaying
high resolution (i.e., least significant digits), the decimal point flashes ON and OFF
repeatedly (see “…About frequency settings”). The Crossover frequency can be
displayed from any channel, but can only be changed from the Installer Channel
(see “…About the current channel
”
). A Crossover frequency is only required when
the Frequency Mode is set to Downlink (dnLn), and is not valid if set to L-Band 1
[Lb1] or L-Band 2 [Lb2]. For more information about frequency settings, see
“Setting up the receiver”.
)DFWRU\5HVHW
The Factory Reset option is an Alt-1 Mode function, and is used to replace the cur-
rent receiver settings with the factory default settings. If you are unsure about us-
ing factory default settings, contact your dealer/reseller, or local service provider.
For information about factory default receiver settings, see “Setting up the re-
ceiver” (see also Table 8).
To perform a Factory Reset
Step 1. Press 0 and then press SELECT to display the Installer Channel.
Step 2. Press ALT once to change from normal operation to Alt-1 Mode.
The ALT LED flashes ON and OFF.
Step 3. Press the Up Ï and Down Ð arrow buttons simultaneously.
The front panel displays do?.
Step 4. Press the Left Í and Right Î arrow buttons simultaneously to initiate the
Factory Reset (pressing any other key aborts the action).
Repeat this action to restore the factory default settings. Once initiated, a Factory
Reset cannot be interrupted or reversed. A Factory Reset can only be performed
from the Installer Channel (see …About the current channel”).
)UHTXHQF\
The Frequency option is an Alt-1 Mode function. The displayed Frequency is the
current Downlink [dnLn], L-Band 1 [Lb1] or L-Band 2 [Lb2] operating frequency
used by the receiver for tuning the received digital signal. If you are unsure about
which Frequency to use, contact your dealer/reseller, or local service provider.
To display or change the operating Frequency
Perform the first step if you are changing the operating Frequency.
Step 1. If required, press 0 and then press SELECT to display the Installer Channel.
Step 2. Press ALT once to change from normal operation to Alt-1 Mode.
The ALT LED flashes ON and OFF.
