Schulte Titan 5000 II Series, Operator'S Manual, Page: 72 / 108

OPERATION
Titan 5000 Series II 01/22 Operation Section 4-10
© 2022 Alamo Group Inc.
OPERA
T
ION
The clevis tongue can be bolted together in two configurations, solid or open depending on your requirements.
To change the clevis configuration, remove the 3/4” x 2-1/2” bolt, flip the clevis halves around and reinsert the
bolt into the specified hole.
Attach safety chain to rock picker and tractor. Pass
large loop safety chain through lug on rock picker
hitch pole. Then pass hook end of safety chain
through large loop. Refer to your tractor operators
manual for complete instructions to attach chain to
tractor. Adjust length to allow only enough slack as
is needed for turning. Lock hook on chain.
Ensure chain rating is equal to or greater than gross
weight of towed implement.
Do not use safety chain for towing. Replace entire chain if any link or end fitting is broken,
stretched or otherwise deformed.
Safety Tow Chain
If the implement is towed on a public roadway, a safety chain with tensile strength equal to or greater than the
gross weight of the unit must be connected between the tractor and implement. This will help control the
implement in the event the tongue becomes disconnected from the drawbar. Make sure the chain is attached
to a secure location on the tractor to the right and left to check for proper chain length. Adjust length as
necessary and allow only enough slack in the chain to make a maximum turn in both directions. When not in
use, store the safety chain to protect it from mud or standing water by wrapping the chain around the tongue.
Replace the safety chain if on or more links or end fittings are broken, stretched or otherwise damaged or
deformed.
Always shut the Tractor completely down, place the transmission in park, and set the
parking brake before you or anyone else attempts to connect or disconnect the Implement
and Tractor hitches.
(S3PT-15)