Schulte Titan 5000 II Series, Operator'S Manual, Page: 11 / 108

SAFETY
Titan 5000 Series II 01/22 Safety Section 1-5
© 2022 Alamo Group Inc.
SAFETY
Equipment Operation Safety Instructions and Practices
Do not approach the Implement while in motion. Use extreme care near the drive unit to
keep your hands or feet clear of the rotating shaft and drive chain. Contact with the rotating
items can result in serious injury or even death. Stay clear until the implement is securely
parked and all motion has stopped.
(STL-12)
Keep fingers clear of tongue lock pin holes. A sudden movement could cause injury or
even amputate fingers. KEEP CHILDREN AWAY WHEN CHANGING TONGUE
POSITION.
(STL-18)
Never attempt to remove a jam or service the implement until the Implement Hydraulic
Hoses have been DISCONNECTED AND REMOVED from the tractor. Serious body injury
or death can result from entanglement with the rotating components of the conveyer.
(STL-25)
Make sure the PTO shield, integral driveline shields, and input shields
are installed when using PTO-driven equipment. Always replace any
shield if it is damaged or missing.
(S3PT-8)
Operate this Implement only in conditions where you have clear visibility in daylight or with
adequate artificial lighting. Never operate in darkness or foggy conditions where you cannot
clearly see at least 100 yards in front and to the sides of the tractor and implement. Make
sure that you can clearly see and identify passersby, steep slopes, ditches, drop-offs,
overhead obstructions, power lines, debris and foreign objects. If you are unable to clearly
see these types of items discontinue operating this equipment.
(S3PT-21)
Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear a seat belt. Death or serious
injury can result from falling off the tractor and/or becoming pinned or trapped
under the tractor or implement particularly during a rollover accident.
(SG-7)
BEFORE leaving the tractor seat, lower the implement, set the parking
brake and/or set the tractor transmission in parking gear, disengage the
PTO, stop the engine, remove the key, and wait for all moving parts to
stop. Place the tractor shift lever into a low range or parking gear to
prevent the tractor from rolling. Never dismount a Tractor that is moving
or while the engine is running. Operate the Tractor controls from the
tractor seat only.
(SG-9)