14 english
Trouble shooting
Problem
Possible Cause
Help
Motor doesn’t start
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
a-d) Replace all damaged parts before you
use your machine again.
e) Contact your local service centre. Every
attempt to carry out a repair, can be danger-
ous if it is not done by skilled personnel.
Machine gets slower
during work.
Too much pressure put on the workpiece.
Reduce the pressure on the workpiece.
Sanding belt comes off
the drive pulleys.
Belt does not run straight.
Reset the track.
The wood gets burnt
during sanding.
a) Sanding disc or belt covered with grease.
b) Excessive pressure on workpiece.
a) Replace disc or belt.
b) Reduce pressure on workpiece.
Strong vibrations
a) loosely mounted tool
b) defective tool
c) spindle knocks
a) tighten tool
b) change tool
c) repair at a Service-Station
Summary of Contents for OSM100
Page 4: ...Fig 1 1 2 3 4 5 5 15 13 8 9 4 6 7 10 12 14 Fig 2 Fig 3 Fig 4 Fig 5 Fig 6 Fig 7 Fig 8 ...
Page 20: ...20 ...
Page 61: ...61 ...
Page 62: ...62 ...
