Schaerer Siena-2, User Manual

Page: 46 / 198

Page 44 BASL - 02 - V01
User manual
UK
Important:
If when switching on the ma-
chine again the monitoring in-
dicator
blinks and the mes-
sage "Door open" appears,
then the brewing unit has not
been correctly inserted or the
door is not correctly closed.
5.8.11 Automatic cleaning
program
Before starting the cleaning
programme, please fill the wa-
ter tank. Also empty the drip
tray. Then place a large con-
tainer beneath the beverage
outlet (which you can inciden-
tally remove or retract for
cleaning).
5.8.12 Now press on the
cleaning button for at least
4 seconds, until the message
"Tablet" appears. Place both
halves of the cleaning tablet
(yellow and white) into the filler
funnel for coffee powder
.
5.8.13 Press once again the
cleaning button . The
cleaning programme now pro-
ceeds automatically and this is
indicated by the display mes-
sage "Cleaning"
Attention:
Under no circumstances
should you switch the appli-
ance off while the cleaning
programme is running
Note:
If during the cleaning process the indicator signals insufficient
water , refill the water tank and re-install it. The process will be
completed automatically.
Once the cleaning process is
completed (this takes about 6
minutes), your coffee machine
is ready for use again. The
end of the programme is indi-
cated by the display message
"Ready".
Note:
If a milk product was dispensed, the Cappuccino system clean-
ing starts directly after the coffee system cleaning. The following
message is displayed "Capp. Cleaning"
5.8.14 Dismantle the foamer
head and thoroughly clean
each part by hand under run-
ning water.
Reassemble the foamer head
and fit it back onto the ma-
chine.
(see paragraph
5.10
Installation / disassembly of
foamer head
page 46 .)
5.8.15 Fill the cleaning con-
tainer with approximately 300
ml of cold water and then add
the cleaning agent (see the
cleaning agent container label
for the correct dosage).
Example of dosage:
Water =
300 ml
MILK clean = 15 ml
(Part number 061'913)
Place the foamer head tube
into the cleaning container.
The tube end must be touch-
ing the bottom of the cleaning
container! Place a container
(approx. 0.5 litre Capacity) un-
der the foamer head.
5.8.16 Press the button
1x briefly (Rinsing / Clean-
ing). The cleaning program
starts.
The display shows "Cleaning"
(Cleaning duration approxi-
mately 45 seconds)
Wait until "Rinsing water" ap-
pears on the display.
5.8.17 Rinse out the cleaning
container thoroughly with fresh
water and fill it with fresh cold
water.
5.8.18 Press the button
1x briefly (Rinsing / Clean-
ing). The system is rinsed.
The display shows "Rinse"
(Rinse duration approx. 45 se-
conds)
Wait until "Ready" appears on
the display.
90
0'1
20.0
1
0
900'0
62.0
03