15
Save Marine, a division of
Save innovations
3 rue des arts et métiers, 38000 Grenoble, France I +33 (0)4 58 00 34 66 I [email protected]
The adjustment of the orientation of the profile arms is essential: the performance of the
turbine is optimal when facing the water flow.
There are 7 adjustment holes to fit with the
angle of your transom for fixing the stop pin
1. Select the most suitable hole,
2. Install the hydrogenerator in functioning
position,
3. Check that the profil arm is vertical (with
horizontal ship)
4. Tighten the screw.
4.5.3
Adjustment of the control arm
The control arm is part of the hydrogenerator.
It is equipped with an automatic clamcleat, a
backstop and three (3) ropes.
-
A black and white rope to place and
maintain the profile arm and turbine into
functioning position. It is blocked into the
automatic clamcleat.
-
A blue rope to raise the profil arm and
turbine. It is locked thanks to a backstop.
-
A white rope to unlock the guard locking pin
and remove the hydrogenerator from the
home plate.
